1984-Montero · rear axle a · страница 27 из 43 · Открыть оригинал PDF ↗
Differentid Case Assembly
1. Assemble the side gears, side gear thrust spacers, pinion
gears, and pinion washers into the differential case.
NOTE
Install the side gear thrust spacers with the oil grooves
facing the side gears.
2. Install the pinion shaft and thrust block.
NOTE
Do not drive in the lock pin at this time.
3. Adjust the differential gear backlash.
(1) Insert a wedge between the side gear and the pinion
shaft to lock the side gear.
(2) Measure the differential gear backlash with a dial
indicator. (Refer to p. 3-19.)
(3) If the differential gear backlash exceeds the repair
limit, adjust the backlash by installing thicker side
gear thrust spacers.
(4) Measure the differential gear backlash once again,
and confirm that it meets specifications.
4. Align the pinion shaft lock pin hole with the differential
. case lock pin hole and then drive in the lock pin.
(1 lYO63)
5. Stake the lock pin at two points with a punch. (1 lYO61)
6. Clean the ring gear attaching bolts and remove the adhe-
sive from the threaded holes of the ring gear with a M 10
x 1.25 tap. Clean the threaded holes with compressed air.
7. Apply LOCTITE 270 or 27 1 to the threaded holes of the
ring .gear. (S 11564)
8. Install the ring gear into the differential case with the
mating marks ‘properly aligned. Be sure to tighten the
bolts diagonally to the specified torque.
Ring gear bolt tightening torque . . . . , . . . . . . . . . .
80-90 Nm (58-65 ft.lbs.)
3-27
Оригинальная страница руководства
