1984-Montero · rear axle a · страница 15 из 43 · Открыть оригинал PDF ↗
Проверка
1. Check dust cover for deformation and damage.
2. Check oil seal for damage.
3. Check inner and outer bearings for seizure, discoloration
and rough.raceway surface.
4. Check axle shaft for cracks, wear and damage.
Checking of the Axle Shaft for Runout
With the axle shaft supported at the center holes on both
ends, measure the axle shaft flange face for runout with a
dial indicator.
Axle shaft runout [Service limit] . . . . . . . . . . . . . .
0.1 mm (.004 in.)
REASSEMBLY
1. Apply the specified wheel bearing grease to the outside
circumference of the bearing outer race.
Recommended mu1 tipurpose grease . . . , . . . . . . . ,
SAE 53 1 Oa, NLGI grade #2EP
2. Press the bearing outer race into the bearing case with
the special tools. ( 1 lSO20)
3. Apply the specified wheel bearing grease to the outside
circumference of the new oil seal. (11 SO2 1)
Recommended, multipurpose grease . . . . . . . . . . . .
SAE 53 1 Oa, NLGI grade #2EP
4. Press the new oil seal into the bearing case with the
special tools until it is flush with the surface of the
bearing cases. ( 11 SO2 1)
5. Apply the specified wheel bearing grease to the lip of the
oil seal. ..
Recommended multipurpose grease . . . . . . . . . . . .
SAE 53 1 Oa, NLGI grade #2EP
6. Apply the specified wheel bearing grease to the roller
surfaces of the bearing inner race.
Recommended multipurpose grease . . . . . . . . . . . .
SAE 53 1 Oa, NLGI grade #2EP
7. Install the rear brake assembly, the bearing case, and the
bearing inner race in that order to the axle shaft.
8. Press the bearing inner race onto the axle shaft with
the special tool. ( 1 lSO22)
Оригинальная страница руководства
