1984-Montero · rear axle a · страница 16 из 43 · Открыть оригинал PDF ↗
9. Pack the bearing case with the specified wheel bearing
grease.
Recommended multipurpose grease . . . . . . . . . . . .
SAE 53 1 Oa, NLGI grade #2EP
10. Install the lock washer and the lock nut with the cham-
fered side in the direction shown in the illustration. When
installing the lock washer, align the tab of the lock
washer with the slot in the axle shaft. (1 lS547)
NOTE
Apply the specified wheel bearing grease to the threaded
portion of the axle shaft before installing the lock nut.
. Recommended multipurpose grease . . . . . ; . . . . . .
SAE 53 1 Oa, NLGI grade #2EP
11. Tighten the lock nut to the specified torque using the
special tool.
Rear axle bearing lock nut tightening torque . . . . .
,180-220 Nm (130-159 ft.lbs.)
12. Bend the tabs of the lock washer into the slots of the
lock nut. ,
NOTE
If the slots in the lock nut and the tabs of the lock washer are
out of alignment, tighten the lock nut until they align.
INSTALLATION
1. Apply the specified wheel -.bearing grease to the oil seal
area of the rear axle housing. :
Recommended’multipurpose grease . . . . . . . . . . . .
.. SAE J3 1 Oa, NLGI grade #2EP
2. Drive the new oil seal. into the end of the rear axle
housing.with-the special tools. (1 lS5 13)
3. Apply the’ specified wheel bearing grease to the oil’ seal
lip.
Recommended multipurpose grease . . . . . . . . . . . .
SAE J3 1 Oa, NLGI grade #2EP
Оригинальная страница руководства
