1984-Montero · rear axle a · страница 38 из 43 · Открыть оригинал PDF ↗
INSPECTION AND REPAIR
Wash the disassembled parts in cleaning solvent and dry them
with compressed air, then check the following areas.
NOTE
For inspection information other than that given below,
refer to p. 3-24.
Inspection of Friction-Plates and Discs for Wear
(1) In order to check the wear, measure the thicknesses
of the friction surfaces and projections of the friction
discs and plates, and then find the difference.
(The same procedure is used for the spring discs and the
spring plates.) (1 lS670)
Clutch plate thickness [Service limit] . . . . . . . . . .
0.1 mm (.004 in.) or Iess
NOTE
Make the measurement at several different points.
(2) If the parts are worn beyond the allowable limit, replace
them with new parts.
Refer to the section regarding adjustments for infor-
mation concerning selection of thickness.
Inspection of Thrust Washer for Wear
(1) Measure the thickness of the thrust washer. (1 lF087)
Thrust washer thickness [Service limit ] . . . . . . . . .
1.4 mm (.55 in.) 0.r more
(2) If the thrust washer is worn beyond the limit, replace it
with a new one. Refer: to the section regarding adjust-
ments for information concerning selection of thickness.
Оригинальная страница руководства
