MANUALS · FRONT AXLE [26] · страница 9 из 64 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
DRIVE SHAFT AXIAL PLAY CHECK
VEHICLES WITH AUTOMATIC FREE-WHEELING HUB
Place the free-wheeling hub in the free condition.
NOTE
The free condition can be obtained by shifting the trans-
fershift levertothe2Hpositionandthenmovingin
reverse forto2meters (3.3 to 6.5 ft)
Jack the vehicle up and remove the front wheels
3Remove the free-wheeling hub cover
Rotate the drive shaft forward, andbackward andthen
set thedrive shaft tothe position (the positionwhere
axial play is maximum) mid-way between where the rota-
tion feels'heavyforeach(wherethere isstopping
feeling)
5.Set thedialgaugeasshown in the figure; thenmove
thedrive shaft intheaxial directionandmeasure the
play.
Standard value: 0.4-0.7 mm (0.016-0.028 in.)
6If the play is out of standard value, adjust by addingor
removing shims:
VEHICLES WITH MANUAL FREE-WHEELING HUB
Jack the vehicle up and remove the front wheels
2Move the control handle for the free-wheeling hub to the
FREE position.
Remove the free-wheeling hub cover.
Set thedial gaugeas shown in the figure; thenmove
the drive shaft intheaxialdirectionandmeasurethe
play:
Standard value: 0.4-0.7mm (0.016-0.028 in:)
5_If the play is out of standard value, adjust by adding or
removing shims
VEHICLES WITHOUT FREE-WHEELING HUB
Jack the vehicle up and remove the front wheels:
2Remove the hub cap.
3Manually push the drive shaft in the direction in which it
will closely contact the knuckle.
Asshowninthefigure,usethicknessgaugeto
measuretheclearancebetweenthedrive flangeand
snap ring:
Standard value: 0.4-0.7mm (0.016-0.028 in )
5If the play is out of standard value, adjust by adding or
removing shims
Оригинальная страница руководства
