MANUALS · FRONT AXLE [26] · страница 21 из 64 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Проверка

EZ6ICAC

BRAKE ASSEMBLY THICKNESS

Check the brake assembly thickness by following the steps
below.

(1) Assemble brake(A) andbrake (B)and thenuse slide
calipers to measure the thickness of the assembly at the
two lugs on brake (A).

Standard value:10.5 mm (0.413 in.)
Limit: 9.6 mm (0.378 in.)

NOTE

Measure each side separately_

(2)If themeasured value is below the limit, replace brake
(A) and brake (B) asa set.

DETERIORATION OF RETURN SPRING

Checkthereturn springfordeteriorationby followingthe
steps below.

(1)Measure the dimensionA shown in illustration at the op
posite side of spring end.

Limit: 35 mm (1.38 in )

Caution

Tomeasure the dimensionA shownin illustration,
measurethedimensionfromtheoutermostex-
tremityofonewirediameterto thatof theother
wire diameter.

(2)themeasuredvalueisbelowthe limit, replacethe
spring:

DETERIORATION OF SHIFT SPRING

Checktheshiftspringfordeteriorationby followingthe
steps below.
(1)Measure the dimensionB shown in illustration at the op
posite side of spring end:

Limit:30 mm (1.18 in,)

Caution

TomeasurethedimensionBshownin illustration,
measurethedimensionfromtheoutermostex-
tremity ofonewirediametertothatof theother
wire diameter.

(2) Ifthemeasuredvalueisbelowthe limit, replacethe
spring:

SERVICE POINTS OF REASSEMBLY

EZ6JDAC

12. INSTALLATION OF RETURN SPRING

Install thereturnspringwith the smaller coildiameter
side toward the cam:

Оригинальная страница руководства