MANUALS · FRONT AXLE [26] · страница 56 из 64 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
(3)Measure the drive pinion rotation torque (without the
oil seal) by using the special tools_
Standard value:
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Gvisiog | Bearing lubrication | Rotation torque |
|---|---|---|
| New | None JWith anti-rust agent) | 0.3-0.5 Nm 3.0-5.0 kgcm 2.6-4.3 in.Ibs |
| Newlreusing | Gear oil applied | 0.15-0.25 Nm 1.5-2.5 kgcm 1.3-2.2 in.Ibs |
NOTE
Gradually tighten the nut of the special tool while
checking the drive pinion preload,
Becauseonerotationcan'tbemadewhenthe
special tool isincontactwiththegear carrier
move ita few times and,after seating the bear-
ing, measure the rotation torque_
(4) Position the special tool in the side bearing seat of
the gear carrier,and then selecta drive pinion front
shimofthicknesswhich correspondstothegap
between the special tools_
NOTE
Be sure to clean the side bearing seat thoroughly
When positioningthe special tool,besurethat
the cut-out sections of the special tool are in the
position shown in the illustration, and also confirm
that the special tool is in close contact with the
side bearing seat
2When selecting the drive pinion front shims, keep
the number of shims toa minimum
(5) Fit the selected drive pinion front shim(s) to the drive
pinion,andpress-fitthedrivepinion frontbearing
inner race byusingthe special tool.
Оригинальная страница руководства
