MANUALS · FRONT AXLE [26] · страница 45 из 64 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
11 , BEARING
10. REMOVAL OF CLUTCH GEAR
(1)Use a press and steel plate to remove the clutch gear and
bearing together:
(2) Use a press to hold the supports against the bearing in-
ner race, and separate the clutch gear and bearing:
SERVICE POINTS OF REASSEMBLY
13. INSTALLATION OF OIL SEAL
Use the special toolto tap the oil seal until it is flush with the
clutch housing:
12. INSTALLATION OF CAP
Use a steel pipe with an outside diameter of approximately
30 - 35 mm (1.1838 in ) to push in the sealing cap.
Caution
Be careful not to make a dent in the curved surface ofthe
cylinder cap:
11. INSTALLATION OF BEARING10. CLUTCH GEAR
(1)Use the special tool to press-fit the bearing to the shoul-
der of the clutch gear:
Оригинальная страница руководства
