MANUALS · FRONT AXLE [26] · страница 63 из 64 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF DISASSEMBLY

1.REMOVAL OF SCREW

Evenly loosen4 screws on caseA and B to remove
(2) Set case B downward and remove case A,side gear
spacer (RH) and side gear (RH):

NOTE

Check differential gear backlash to determine neces-
sity of disassembling side gear (RH) ad onward.

DIFFERENTIAL GEAR BACKLASH CHECK

Check differential gear backlash as follows_

(1) Insertclothwrappedscrewdriverthroughsideof
caseB and lock side gear (LH) and pinion gear_(one
piece)

(2} Contact dial gauge on pinion gear facing the locked
pinion gear and measure backlash within the standard
value.

NOTE

Measure 2 pinion gears_
Standard value: 0.01-0.25 mm

(0.0004-0.0098 in )

(3)When backlashexceedsthestandard value, adjust
side gear spacer (LH).

NOTE

If backlash is withinthe standardvalue ,assureap
propriate gear spacer (RH) thickness and assemble
pinion case assembly.(Refer to P.26-57.)

SERVICE POINTS OF REASSEMBLYEZ6WNAB BACKLASHADJUSTMENTONDIFFERENTIALGEAR CASE B SIDE

caseB side as fol-
Adjust backlashon differential gear
lows

Temporarily install side gear spacer (LH), , sidegear
(LH); washers,2 pinion gears and pinion shafton
case B_

NOTE

Donot assemble pinion shaft holder, pinion shaft-B
or the remaining pinion gears (2).

(2)Insert wrapped screwdriver through side of case B to
lock one side of pinion gear and side gear (LH)

Оригинальная страница руководства