MANUALS · FRONT AXLE [26] · страница 15 из 64 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF INSTALLATION

E28IDAH

ADJUSTMENT OF WHEEL BEARING PRELOAD

(1) Using the special tool, tighten the lock nut by the fol-
lowing procedures:

Tighten to 130-200 Nm
(13-20 kgm, 94-145 ftIbs )

Loosen to 0 Nm (0 kgm,0 ft.Ibs )

Retighten to 25 Nm (2.5 kgm;,18 ft.Ibs )
and then loosen 300_409

(2)Installthelock washerIfthehole positionisnot
alignedwith the lock nut,move it withinrange of
not more than 209 until the holes are aligned:

(3)Loosen the lock nut approximately 30 to 40 degrees
to adjust the front hub's turning resistance and play
intheaxialdirectionSOthatthey agreewiththe
standard values:

Standard value: 0.3-1.3 Nm

(3-13 kgcm;, 2.6-11.3 in.Ibs:)
[Spring scale reading]
5-18 N
(0.5-1.8 kg; 1.1-4.0 Ibs:)
Standard value:0.05 mm (0.0020 in.) or less

NOTE

If adjustment is not possible,the bearing may be in-
correctly installed; check and,if necessary, repair.
The lubrication condition should as also be checked.

(4)Mount the lock washer:If the lock washer holes do
not align with the lock nut holes, loosen the lock nut
to align them:

Mitsubishi Motors CorporationFeb_1991

INSTALLATIONOFAUTOMATICFREE-WHEELING HUB ASSEMBLY

(1) Align thekeyof thebrake (B)andthekeywayof
knuckle spindle and loosely install the automatic free-
wheeling hub assembly

(2) Check that the hub proper and automatic free-wheel-
inghubassemblyare brought into intimatecontact
when the assembly is forced lightly against the hub
proper.If not, turn the hub until intimate contact is
achieved.

PWJE9086

Оригинальная страница руководства