MANUALS · FRONT AXLE [26] · страница 16 из 64 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
ADJUSTMENT OF AUTOMATIC FREE-WHEELING HUB TURNING RESISTANCE
Check the automatic free-wheeling hub turning resistance
by the following procedure
Usespring scale to measure the front hub turning
resistanceagain.Subtractthevaluemeasured
before the installation of the automatic free-wheeling
'hubfromthatmeasured hereto findthe turning
resistance of the free-wheeling hub
Limit:
1.0 Nm (10 kgcm, 8.7 in. Ibs )
[Spring scale reading] 14 N (1.4 kg, 3.1 Ibs )
(2) If the free-wheeling hub turning resistance exceeds
thelimit,disassembleandreassemblethefree-
wheeling hub again.
ADJUSTMENT OF DRIVE SHAFTAXIAL PLAY
Afterthe installation ofshimandsnap ring; checkthe
drive shaft axial play by the following procedure
<Vehicles with drive flangez
(1) Install the shim and snap ring to the drive shaft
(2) Push the drive shaft in by hand towards the knuckle until
theytouch:
(3) Measure the clearance between the drive flange and the
spacer withthickness gauge as shownin the illustra-
tion.
Standard value: 0.4-0.7mm (0.016-0.028in.)
(4)If the amount of play is outside the standard value, ad-
just by selecting a shim that will bring the play to the
standard value
<Vehicles with free-wheeling hubsz
(1)Rotate the drive shaft forward,and backward and then
setthedriveshaft to the position (the positionwhere
axial play is maximum) mid-way between where the rota-
tion feels'heavyforeach(where there isstopping
feeling)
move
(2) Set the dial gauge as shown in the figure; then
the drive shaft inthe axial directionandmeasurethe
play:
Standard value: 0.4-0.7mm (0.016-0.028 in:)
(3) If the play is out of standard value, adjust by adding or
removing shims_
Оригинальная страница руководства
