MANUALS · SERVICE BRAKES [35] · страница 85 из 140 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
ACTUATOR TEST SPECIFICATIONS
CHECK AT ABS-ECU
TERMINAL VOLTAGE CHECK CHART
Measure the voltages between terminals (15), (25) and (42) (earth terminals) and each respective terminal:
2The terminal layouts are shown intheillustrations below:
14wo043
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Item No. | Signal | Checking Requirements | Normal Condition |
|---|---|---|---|
| Output to front-left hydraulic unit solenoid valve (OUT side) | |||
| Output to rear hydraulic unit solenoid valve (OUT side) | Ignition switch: ON (When solenoid valve is off approximately second after engine is started) | System voltage | |
| Output to rear hydraulic unit solenoid valve (IN side) | |||
| G-sensor signal | Ignition switch: ON | 2.5 +0.12V (Horizontal condition) | |
| 13 | ABS-ECU power supply | Ignition switch: ON | System voltage |
| Ignition switch: START | 0 V |
Оригинальная страница руководства
