MANUALS · SERVICE BRAKES [35] · страница 98 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Service Adjustment Procedures

REARDISCBRAKEPADCHECKAND
REPLACEMENTE35FUAC

Check brake pad thickness through caliper body check port:
Standard value:9.0 mm (0.35 in.)
Limit:2.0 mm (0.079 in,)

Caution

When the limit is exceeded, replace the pads at both
sides, and also the brake pads for the wheels on the
opposite side at the same time.

2If there is a significant difference in the thicknesses
of the pads on the left and right sides, check the slid-
ing condition of the piston, lock pin sleeve and guide
pin sleeve:

2Remove lock pin: Lift caliper assembly and retain with wires_
Caution

Do not wipe off the special grease that is on the lock pin
or allow it to contaminate the lock pin:

3.Remove the following parts from caliper support.
(1) Outer shim

(2) Pad assembly

(3) Pad and wear indicator assembly

(4)Clip

In order to measure the dragging force of the disc brakes af-
ter installation of the brake pads, usespring balance to
measure the rotational sliding resistance of the hub in the
forward direction with the pads remove

NOTE

To secure the disc to the hub, tighten the nuts,

5.Securely attach the pad clip to the caliper support.
Caution

Do not deposit grease or other dirt on pad or brake disc
friction surfaces:

Оригинальная страница руководства