MANUALS · SERVICE BRAKES [35] · страница 99 из 140 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
6Clean pistonand insertinto cylinderwith special tool.
Be careful that the piston boot does not become caught,
when lowering the caliper assembly &nd installthelock
pin:
Start the engine and, after strongly depressing the brake
pedal 2-3 times, stop the engine_
8Turn brake disc forward 10 times.
9Use a spring balance to measure the rotational sliding resis-
tance of the hub in the forward direction:
10. Calculate the dragging force of the disc brakes (the differ-
ence between the values measured in steps 9 and 4)
Standard value: 57N (5.7 kg: 13 Ibs ) or less
11. Ifthe dragging force of the disc brakes exceeds the standard
value, disassemble piston and clean the piston. Check for
corrosion or worn piston seal, and check thesliding condition
of the lock pin sleeve and guide pin sleeve
REAR BRAKE DISC THICKNESS CHECK
E35FVAB
Remove dirt and rust from brake disc surface
2Measure disc thickness at4 locations or more.
Standard value:18.0mm (0.71 in.)
Limit:16.4 mm (0.646 in.)
Replace the discs and pad assembly for both sides left
areworn
and right ofthe vehicleif theybeyondthe
specified limit
REAR BRAKE DISC RUN-OUT CHECK
E35PWAB
Remove the caliper support,raise the caliper assembly,
and secure it byusinga wire, etc.
Mitsubishi Motors Corporation
Оригинальная страница руководства
