MANUALS · SERVICE BRAKES [35] · страница 97 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

FRONT BRAKE DISC RUN-OUT CORRECTION

Ifthe run-out of thebrake disc is equivalent to or exceeds the
limit specification, change the phase of the discand hub, and
then measure the run-out again: (Refer to P 35-44)

2If the run-out cannot be corrected by changing the phase of
the brake disc, replace the disc or turn rotor with on the car
type brake latheMAD, DL-8700PForequivalent)

FRONT BRAKE DISC THICKNESS CHECKE35FRAB

Inspect the disc surface for grooves, cracks, and rust. Clean
the disc thoroughly and remove all rust

2Using a micrometer; measure disc thickness at eight posi-
tions, approximately 458 apart and 10 mm (0.39 in.) in from
the outer edge of the disc

Standard value:24 mm (0.94 in:) <Except 3500>
27 mm (1.01 in.) <3500>
Limit:22.4 mm (0.882 in.) <Except 3500>
25.4 mm (1.0 in.) <3500>

The differencebetweenthicknessmeasurements
any
should not be more than 0.015 mm (0.0006 in.)

3Replace the discs and pad assembly for both sides left and
right ofthe vehicle iftheyare beyond the limits for thickness
If thickness variation exceeds the specification, replace the
disc or turn rotor with on the car type brake lathe ("MAD
DL-8700PForequivalent)

Оригинальная страница руководства