MANUALS · SERVICE BRAKES [35] · страница 101 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

BRAKE LINING THICKNESS CHECK

Remove the rear brake assembly ad secure it with wire
2Remove the brake drum_

3Measure thewear of the brake lining at the place worn
themost;

14E0124

6.5mm (0.256 in.)
4,5 mm (0.177 in.)

Standard value: Limit:

Replacetheshoeandliningassemblybrake lining
thickness is less than the limit if it is not worn evenly:
For information concerning the procedures for installation
of theshoe ad lining assembly, refer to GROUP 36
Parking Brake Drum:

Caution

Whenevertheshoeandis
liningassembly
replaced, replace both RH and LH assemblies as
set to prevent car from pulling to one side when
braking

2Ifthereissignificant differenceinthe thick-
nesses of the shoe and lining assemblieson the
left and right sides, check the sliding condition of
the piston:

BRAKE DRUM INSIDE DIAMETER CHECKE35FGAA
Remove the rear brake assembly and secure it with wire.
2.Remove the brake drum:

3Measure the inside diameter of the brake drum at two or
more locations.

Standard value:
Limit:

197mm (7.76 in.)
198 mm (7.8 in.)

Replace brake drums and shoe and lining assembly when
wear exceeds the limit valueor is badly imbalanced;

14E0036

BRAKELININGANDBRAKEDRUMCONNEC- TION CHECKE35FIAA

E35FIAA

Remove the rear brake assembly and secure it with wire _
Remove the brake drum_

2

3_Remove the shoe ad lining assembly, refer to GROUP
36Parking Brake Drum:
Chalk inner surface of brake drum and rub with shoe and
lining assembly

5Replace shoe and lining assembly or brake drums ifvery
irregular contact area.

For information concerning the procedures for installation
of the shoe and lining assembly, refer to GROUP 36
Parking Brake Drum:

NOTE

Wipe off chalk after check:

Оригинальная страница руководства