MANUALS · SERVICE BRAKES [35] · страница 106 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

ServiceAdjustmentProcedures

G-SENSOR OUTPUT VOLTAGE CHECK <ABS>

Unload the vehicle and move it toa horizontal surface
2Turn the ignitionkeyto the ACC position and connect
themulti-use testerOrMUT-II asshown in the illustra-
tion.

Caution
Make certainthatthe ignition switch is OFFwhen
themulti-use tester or MUT-IIisconnectedor dis-
connected:

3_Start the engine.

Caution

Atthis time,checkthattheABSwarninglamp
momentarily illuminates before turning off:
Ifitdoesnotturnoff,referto"Troubleshooting
(P.35-6).

Check whether the G-sensor output voltage is within the
standard value range_

Standard value:2.5+0.44 V

<Vehicles built up to October, 1993>
2.5+0.12 V

<Vehicles built from November, 1993>

5If the G-sensor output voltage is not within the standard
value range, check the installation condition of the G sen-
sor; if there is bolt loose,deformationof the G-sensor
bracket;etc , repair it,If the problem isnot repairable ,
replacetheG sensor.

AB.S POWER RELAY CHECK <AB.S >

Remove the AB.S_power relay:

Оригинальная страница руководства