MANUALS · GENERAL [00] · страница 4 из 52 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

EXPLANATION OF MANUAL CONTENTS

Indicates procedures to be
performed before the work in that
section is started, and procedures
to be performed after the work in
that section is finished

Maintenance and Servicing Procedures

Removal steps:

The part designation number corresponds
to the number in the illustration to indicate
removal steps_
Disassemblysteps:

(1)A diagram of the component parts is
provided near the front of each section
orderto give the readera better
understandingof the installed condi-
tion of component parts.

Thepart designation number corresponds
to the number in the illustration to indicate
disassembly steps.

(2)Thenumbersprovidedwithinthe
disassembly steps.
diagramindicatethesequencefor
maintenanceInstallation steps:
and servicingpro-
Specified in case installation is impossible
cedures; the symbolWindicates a non-
in reverse order of removal steps_
reusable part; the tightening torque is
provided where applicable.Omittedif installationis possiblein
reverse order of removal steps.
Reassembly steps:

Specified in case reassembly is impossi-
ble in reverse order of disassembly steps_
Omittedreassemblypossible in
reverse order of disassembly steps

Classifications of Major Maintenance/Service Points

When there are major points relative to maintenance
and servicing procedures (such as essential
maintenance and service points, maintenance and
service standard values, information regarding the use
of special tools, etc ) these are arranged together as
major maintenance and service points and explained in
detail.

Indicates(bysymbols)where
lubrication is necessary.In this
example,multipurpose grease is
to applied (where indicated) to the
knuckle.

Indicates that there are essential points for
removal or disassembly.

Indicates that there are essential points for
installation or reassembly

Symbols for Lubrication, Sealants and Adhesives

Information concerning the locations for
lubrication and for application of sealants
and adhesives is provided, by using
symbols, in the diagram of component
parts or on the page following the
component parts page, and explained.

Grease
(multipurpose grease unless
there is a brand or type specified)
Sealant or adhesive

Brake fluid or automatic
transmission fluid

Engine oil or gear oil

Adhesive tapeor butyl
rubber tape

Оригинальная страница руководства