1987 · Карбюраторная система питания — страница 26

IDLE SPEED AND MIXTURE ADJUSTMENT (For Un- scheduled Maiintenance only) · 26

1987-Montero · Fuel System Carb a · страница 26 из 86 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 26

IDLE SPEED CHECK PROCEDURE N14FHAA
Refer to GROUP 0 LUBRICATION AND MINTENANCE-Check-
ing and adjustment of the idling rpm

IDLE SPEED ADJUSTMENT N14FHBA

Refer to GROUP 0 LUBRICATION AND MAINTENANCE-Idle
Speed Inspection and Adjustment.

Иллюстрация 2, страница 26
Иллюстрация 3, страница 26
Иллюстрация 4, страница 26

1

IDLE SPEED AND MIXTURE ADJUSTMENT (For Un- scheduled Maiintenance only)

1. Remove carburetor from engine. (Refer to P.14-61,)
2. Clamp carburetor in a vice with idle mixture adjusting screw
(MAS) facing up (protect gasket surface from vice jaws).
3. Drill a 2 mm (5/64 inch) pilot hole in the casting surrounding
the idle mixture adjusting screw (MAX) then redrill the hole to
3 mm (l/8 inch).

4. Insert a blunt punch into the hole and drive out plug.
5. Reinstall carburetor on engine.

6. Run the cold engine at fast idle until the cooling water tem-
perature is raised to 80 to 95°C (185 to 205°F).

Inspection Conditions

Engine coolant temperature : 85-95°C (185-205°F)
Light and accessory operation : off
Transmission : neutral (N or P for automatic transmission
equipped vehicles)
Steering wheel : center position (power steering equipped vehi-
cles)

7. Prepare a timing light and tachometer.

8. Check the cycle of the timing light. Adjust if necessary.

Timing light cycle : 7” BTDC f2”

NOTE

Refer to GROUP 8 ELECTRICAL-Ignition System, for the tim-
ing cycle inspection and adjustment procedures.

9. Turn off the ignition key.

10. Disconnect the cable from the negative terminal of the battery
for about 5 seconds. And then reconnect the cable to the
original terminal.
11. Disconnect the connector of the exhaust oxygen sensor.
12. Run the engine for more than 5 seconds at the engine speed
of 2000 to 3000 rpm.

13. Run the engine at idle for 2 minutes.

Иллюстрация 5, страница 26
Иллюстрация 6, страница 26
Иллюстрация 7, страница 26
Иллюстрация 8, страница 26

, ;I, +.I STB Revision
” ,.
I,

Оригинальная страница руководства
14-26 FBC SYSTEM-Service Adiustment Procedures
100%

Назад
Сверху