1987 · Карбюраторная система питания — страница 36

Fuel System Carb a · 36

1987-Montero · Fuel System Carb a · страница 36 из 86 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 36

(1) Check that the alignment marks on the electric choke and
bimetal assembly are lined up. If not, align the marks.

NOTE

1. For removal of the bimetal assembly, refer to DISASSEM-
BLY AND REASSEMBLY (P. 14-67).

2. Misalignment and resultant symptom

MisalignmentSymptom
Clockwise
deviation
Better
startability
but plugs
more
likely to be sooty
Counterclockwise
deviation
Poorer
startability
and more
likely
to stall
Таблица в оригиналеТаблица: оригинал страницы 36

(2) Check that engine coolant temperature is below 10°C (50°F).
(3) Start the engine and check operation of the choke valve and
fast idle cam, with hand on the electric choke body.

Electric
choke
body
Gets gradually
hotter
after engine
start
Choke
valve
Opens
as
bimetal
temperature
rises
Fast idle camFast idle control
is released
as en-
gine
coolant
temperature
rises
and fast idle breaker
operates
Таблица в оригиналеТаблица: оригинал страницы 36

(4) If the electric choke body remains cool even after the engine
is started, check the electric choke.

Иллюстрация 2, страница 36
Иллюстрация 3, страница 36
Иллюстрация 4, страница 36
Иллюстрация 5, страница 36

INSPECTION OF ELECTRIC CHOKE

N14FacA

(1) Disconnect the carburetor connector and check continuity of
the heater.

Normal state : Should be conductive [approx. 6 f3 at
20°C (68”F)]

(2) If the heater is not conductive, replace the electric choke body

(bimetal assembly).
NOTE

Иллюстрация 6, страница 36
Оригинальная страница руководства
14-36 FBC SYSTEM-Service Adjustment Procedures
100%

Назад
Сверху