1987-Montero · Fuel System Carb a · страница 66 из 86 · Открыть оригинал PDF ↗
NICE POINITS OF DISASSEMBLY
Caution
1. DO not disassemble the following components at the time
of disassembly.
(1) Choke valve, choke shaft and automatic choke device
(2) Inner venturi
(3) Throttle valve and throttle shaft
(4) Fuel inlet nipple
2. When loosening a Philips screw which has been firmly
tightened, use a Philips screwdriver that is an exact fit for
the screw.
10. REMOVAL OF FLOAT CHAMBER COVER ASSEMBLY
Caution
Ensure that the terminal is not bent during removal of the
connector.
(1) With a pin or the like push the stopper portion to remove
each of the three TPS terminals from the rear of the con-
nectors.
(2) Do not attempt to remove the cover at a time as it is held
in position firmly by gasket. Insert a screwdriver blade
between the enrichment cover and the float chamber
cover as illustrated and lightly pry and lift up lightly.
c
Caution
Do not apply excessive force.
14. REMOVAL
OF FLOAT / 15. NEEDLE VALVE
Remove the pin and then remove the float and needle valve.
Caution
1. Do not let the float drop or apply collapsing load.
2. Use care not to damage the end of the needle valve.
16. REMOVAL
OF NEEDLE VALVE SEAT
Using flat blade screwdrivers, pry up the needle valve seat at
both edges to remove.
Оригинальная страница руководства
