1987 · Карбюраторная система питания — страница 57

INSPECTION OF FBC SYSTEM COMPO- NENTS NlUMM · 57

1987-Montero · Fuel System Carb a · страница 57 из 86 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 57

INSPECTION OF FBC SYSTEM COMPO- NENTS NlUMM

INSPECTION OF ENGINE COOLANT TEMPERATURE
SENSOR

INSPECTION

(I) Remove engine coolant temperature sensor from the intake
manifold.

Иллюстрация 2, страница 57

(2) With temperature sensing portion of engine coolant tempera-
ture sensor immersed in hot water, check electrical resis-
tance. The sensor should be held with its housing 3 mm (.12
in.) away from the surface of the hot water.

Temperature
“C VF)
Resistance (kfI
0 (32)5.9
20 (68)2.5
40 (104)1.1
80 (176)0.3
Таблица в оригиналеТаблица: оригинал страницы 57

(3) If the resistance deviates greatly from the standard value. re-
place the engine coolant temperature sensor.

INSTALLATION

(1) Apply specified adhesive to threaded portion.
Specified adhesive : 3M Adhesive Nut Locking No.
4171 or equivalent

(2) Install engine coolant temperature sensor and tighten it to
specified torque.
Sensor tightening torque : 20-40 Nm (14-29 ftlbs.)
(3) Fasten harness connectors securely.

INSPECTION OF THROTTLE POSITION SENSOR VW NlUlQAQ

(1) Disconnect the carburetor connector.

(2) Measure resistance between terminal 1 (sensor power) and
terminal 8 (sensor ground).

Иллюстрация 3, страница 57
Оригинальная страница руководства
FBC SYSTEM-Inspection of FBC Svstem ComDonents 14-57
100%

Назад
Сверху