1987 · Карбюраторная система питания — страница 43

INSPECTION OF FBC SYSTEM CAUTIONS ON INSPECTION · 43

1987-Montero · Fuel System Carb a · страница 43 из 86 · Открыть оригинал PDF ↗

Иллюстрация 1, страница 43

INSPECTION OF FBC SYSTEM CAUTIONS ON INSPECTION

N14PAAC

1. Before removing or installing a part, disconnect the battery
0 terminal.

2. Before disconnecting battery terminals, turn off the ignition
switch. Removal or connection of battery terminals during en-
gine operation or with the ignition switch ON could cause
erroneous operation of the ECU or damage to semiconduc-
tors.

3. The control harnesses between ECU and ignition coil [ 0
terminal] and between ECU and oxygen sensor are shield-
ed wires with shield grounded to the vehicle body in order
to prevent ignition noises and radio interference. When the
shielded wire is faulty, therefore, the control harness must
be replaced.

4. When ECI checker is handled, pay attention to the following
points.

l Avoid rough operation of switches.

l Do not subject ECI checker to shock and other external
forces, heat, etc.

l Keep away water and oil.
l Store ECI checker in a moisture- and dust-free place and
take steps to protect the checker from heat and vibration.

Иллюстрация 2, страница 43
Иллюстрация 3, страница 43
Иллюстрация 4, страница 43
Иллюстрация 5, страница 43
Иллюстрация 6, страница 43
Иллюстрация 7, страница 43
Иллюстрация 8, страница 43
Иллюстрация 9, страница 43
Иллюстрация 10, страница 43
Иллюстрация 11, страница 43
Иллюстрация 12, страница 43
Иллюстрация 13, страница 43
Иллюстрация 14, страница 43
Иллюстрация 15, страница 43
Иллюстрация 16, страница 43
Иллюстрация 17, страница 43
Оригинальная страница руководства
FBC SYSTEM-Inspection of FBC System 14-43
100%

Назад
Сверху