Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 87 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Connector Terminal No.	Signal	Checking	Requirements	Normal Condition
45	Input from free-wheeling	Ignition switch:	Engage 2WD	System voltage
	engage switch	ON	Engage 4WD_	1 V or less
46*	Inition switch	Ignition sw	itch: ON	System voltage
	g	Ignition sw	itch: START	0 V
46*2	frorn Input rear differential	Ignition ith	Rear differential lock switch: ON	0 V
	lock detection switch	swc: ON	Reardifferential lock switch: OFF	System voltage
47	Input from diagnosis	Connect th	e MUT-II	0V
	indication selection	Do not con	nect the MUT II	Approx: 12 V
48	Input from valve relay monitor	Ignition s	witch: ON	System voltage
49	Motor monitor	Ignition s Ai	witch: ON Motor is on tl second	System voltage
		(pproxm after engin	ey Motor is off e is started)	0.5 V or less
50	Output to ABS warning lamp	Ignition ith	The lamp is switched off	System voltage
		swc: ON	The lamp illuminates	0-2 V
52	Output to front-right hydraulic unit solenoid valve (IN side)	Ignition s (When sol second aft	witch: ON enoid valve is off approximately er engine is started)	System voltage

NOTE
(1) *1;Vehicles without rear differential lock
(2) +2:Vehicles with rear differential lock

Оригинальная страница руководства