Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 100 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE BRAKES

Adjustment Procedures

Placea dial gauge approximately 5 mm (0.2 in) from the
outer circumference of the brake discand measure the
run-out of the disc

Limit:0.08 mm (0.0031 in.)

NOTE

To secure the disc to the hub, tighten the nuts

REAR BRAKE DISC RUN-OUT CORRECTION

If therun out ofthebrake disc iS equivalent tooreX
ceeds thelimit specification, changethephase of the
disc and axle shaftandthen measure the run-outagain ,
(1)Before removing the brake disc,chalk both sides
thewheelstudonthesideatwhichrun-out
greatest.

(21 Remove the brake disc,and: then placea dial gauge
then move the hub in the axial directionandmeasure
the play.

Limit:0.25 mm (0.0098 in.) or less

(3) If the play does not exceed the limit specification, in
stallthebrakediscatdifferent phase ,andther
check the run-out of the brake disc once again_

2If the runout cannot be corrected by changing the phase
of the brake disc, replace the disc.

Оригинальная страница руководства