Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 97 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

FRONT BRAKE DISC RUN-OUT CORRECTION

Ifthe run-out of the brake disc is equivalent to or exceeds the
limit specification, change the phase of the disc and hub, and
then measure the run-outagain.(Refer to P 35-44)

If the run-out cannot be corrected by changing the phase of
the brake disc, replace the disc or turn rotor with on the car
type brake latheMAD, DL-8700PFor equivalent)

FRONT BRAKE DISC THICKNESS CHECK

E35FRAB

Inspect the disc surface for grooves, cracks, and rust: Clean
the disc thoroughly and remove all rust.

2Using a micrometer; measure disc thickness at eight posi-
tions, approximately 45" apartand10 mm (0.39 in.) in from
the outer edge of the disc_

Standard value:

24 mm (0.94 in.) <Except 3500>
27 mm (1.01 in.) <3500>

22.4 mm (0.882 in.) <Except 3500>
25.4 mm (1.0 in.) <3500>

Limit:

Thedifferencebetweenanythicknessmeasurements
should not be more than 0.015 mm (0.0006 in.)

3Replace the discs and pad assembly for both sides left and
right ofthe vehicle if theyare beyond the limits for thickness
If thickness variation exceeds the specification, replace the
disc or turn rotor with on the car type brake latheMAD,
DL-87O0PFor equivalent) .

Оригинальная страница руководства