Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 92 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

ServiceAdjustment Procedures

Disconnect the spring at the support side

3Placethe springSOthat it is in parallel withthe load-
sensing proportioning valve,and then pull in the direction
indicated by arrowA so that its length H shown in the
figure (the length between its ends) is as noted below.
NOTE

At this time the lever is pressed all the way to the load-
sensing proportioning valve side_

Check at this time whether or not the output fluid's pres-
sure,relativetOthe load-sensingproportioningvalve 's
input fluid pressure, is within the standard value

Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Items	Spring length H mm (in.)	Input fluid pressure MPa (kg/cm? , psi)	Output fluid pressure MPa (kg/cm? , psi)
2-door models	227.5 (9.0)	10 (100, 14221	5.37-6.27 (53.7-62.7 , 763.8-891,8)
		18 (180, 25601	7.17-8.47 (71,.7-84.7 , 1019.8-1204.7)
4-door models	226_ (8.91	10 (100, 14221	6.14-7.04 (61.4-70.4, 873.3- 1001.3)
		18 (180, 2560)	7.94-9.24 (79.4-92.4, 1129.3-1314.2)

In the same manner as in step 3._check whether or not
theoutput fluid'spressure,relativetothe load-sensing
proportioningvalve'sinputfluidpressureiswithinthe
standard valve when the spring's length H is the dimen-
sion noted below

Standard value:

Таблица в оригинале

Распознанный текст таблицы — требует сверки с оригиналом

Items	Spring length mm (in.)	Input fluid pressure MPa (kglcm?, psi)	Output fluid pressure MPa (kglcm? psi)
2-door models	255.6 (10.1)	18 (180, 25601	13.1-15.1 (131-151, 1863.3-2147.7)
4-door models	257.7 (10.1)	25601 18 (180,	10.4-12.4 (104-124, 1479.2-1763.7)

After making the check, install the springDisconnect the
pressuregaugesfromtheload-sensingproportioning
valve and bleed the air.

Fab.1991

PWJE9O8B

Оригинальная страница руководства