Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 130 из 140 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
SERVICE POINTS OF DISASSEMBLY
REMOVAL OF PISTON BOOT/8. PISTON
Protect caliper bodywithcloth:Blow compressedair
through brake hose to remove piston boot and piston:
Caution
Blow compressed air gently:
9REMOVAL OF PISTON SEAL
(1)Remove piston seal with finger tip
Caution
Donotuse0-)screwdriverOrothertoolto
prevent damage to inner cylinder
(2) Cleanpistonsurfaceandinnercylinderwith
trichloroethylene , alcohol or specified brake fluid.
Specified brake fluid:DOT3or DOT4
INSPECTION PAD WEAR
E35RHAC
Measure thickness at the thinnest and worn area of the pad.
Replace pad assembly when pad thickness is less than the
limit value.
Standard value:9.0 mm (0.35 in.)
Limit:2.0mm (0.079 in.)
Caution
When the limit is exceeded, replace the pads at both
sides, and also the brake pads for the wheels on the
opposite side at the same time:
2If there issignificant difference in the thicknesses
of thepadsontheleftand right sides,checkthe
sliding parts:
SERVICE POINTS OF REASSEMBLYE3SRIAD
2INSTALLATION OF GUIDE PIN/1. LOCK PIN
Install the guidepinandlockpinas illustrated so that
eachheadmarkoftheguidepinandthelockpin
matches the indication mark ("Gor "L") located on the
caliper body.
Оригинальная страница руководства
