Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 106 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

G-SENSOR OUTPUT VOLTAGE CHECK <ABS>

Unload the vehicle and move it toa horizontal surface
2Turnthe ignition keyto theACC position and connect
themulti-use testerorMUT-II as shown in the illustra-
tion.

Caution
Make certainthat the ignitionswitch is OFFwhen
themulti-usetesteror MUT-IIisconnectedordis-
connected:

3Start the engine.

Caution

Atthis time,checkthattheABSwarning lamp
momentarily illuminates before turning off,
Ifitdoesnotturnoff ,referto"Troubleshooting
(P.35-61 .

Check whether the G-sensor output voltage is within the
standard value range_

Standard value:2.5+0.44 V

<Vehicles built up to October, 1993>
2.5+0.12 V
<Vehicles built from November, 1993>

5.If the G-sensor output voltage is not within the standard
value range, check the installation condition of the G sen-
sor; ifthere isbolt loose, deformation of the G-sensor
bracket,etc , repairIf the problem is not repairable
replace theG sensor

ABS. POWER RELAY CHECK <ABS>

E35FPAEa

Remove the A.B.S. power relay.

Оригинальная страница руководства