Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 123 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

SERVICE POINTS OF INSTALLATION

E3SLBAG

INSTALLATION OFFRONT BRAKEASSEMBLY

After installation of the brake assembly,measure the drag-
ging force of the disc brakes by the following procedure.
(1) With the brake assembly removed, use a spring balance
to measure the rotational sliding resistance of the hub in
the forward direction:

(21 After installing the caliper support to the knuckle, use
the special tool to expand the piston, and then install
the caliper body:

(31 Start the engine and, after strongly depressing the brake
pedal 2-3 times, stop the engine
Turn brake disc forward 10 times

(51Use a spring balance to measure the rotational sliding re-
sistance of the hub in the forward direction.

(6)Calculate the dragging force of the disc brakes (the differ
ence between the values measured in steps 5 and 1).

Standard value: 57N (5.7 kg; 13 Ibs ) or less

If the dragging force of the disc brakes exceeds the stan-
dard value, disassemble piston and clean the piston
Check for corrosion or worn piston seal.

Оригинальная страница руководства