Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 99 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

6Clean pistonandinsertinto cylinderwith specialtool,
Be careful that the piston boot does not become caught;
when lowering the caliper assembly and install the lock
pin.

Start the engine and, after strongly depressing the brake
pedal 2-3 times, stop the engine_
Turn brake disc forward 10 times

9.Use a spring balance to measure the rotational sliding resis-
tance of the hub in the forward direction.

10. Calculate the dragging force of the disc brakes (the differ-
ence between the values measured in steps 9 and 4) .

Standard value: 57N (5.7 kg: 13 Ibs ) or less

11. Ifthe dragging force of the disc brakes exceeds the standard
value , disassemble piston and clean the piston. Check for
corrosion or worn piston seal, and check the sliding condition
of the lock pin sleeve andguidepin sleeve.

REAR BRAKE DISC THICKNESS CHECK

E3SFVAB

Remove dirt and rust from brake disc surface
2_Measure disc thickness at4 locationsor morc
Standard value:18.0 mm (0.71 in,)
Limit;16.4mm (0.646 in.)
Replace the discs and pad assembly for both sides left
and rightofthevehicleif theyareworn beyondthe
specified limit .

REAR BRAKE DISC RUN-OUT CHECK

E35PWAB

Remove the caliper support, raise the caliper assembly,
and secure it by using a wire, etc

PWJE9O8S-A

Оригинальная страница руководства