Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 88 из 140 · Открыть оригинал PDF ↗
Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.
RESISTANCE AND CONTINUITY BETWEEN HARNESS-SIDE CONNECTOR TERMINALS
Turn the ignition switch off and disconnect the ABS-ECU connectors before checking resistance and conti-
nuity.
Check them between the terminals indicated in the table below:
3_Theterminal layouts are shown in the illustrations below.
Таблица в оригинале
Распознанный текст таблицы — требует сверки с оригиналом
| Connector Terminal No. | Signal | Normal Condition |
|---|---|---|
| Body earth | Front-left solenoid valve (OUT side) | 4.7 +0.25 9 |
| Body earth | Rear solenoid valve (OUT side) | 4.7 +0.25 2 |
| Body earth | Rear solenoid valve (IN side) | 9.0 + 0.5 Q |
| 7-20 | Front-left wheel speed sensor wire) | 0.9+1.1 Q |
| 8-21 | Rear-right wheel speed sensor (+ wire) | 1,3+219 |
| 9-22 | Rear-left wheel speed sensor wire) | 13+2.19 |
| 10-23 | Front-right wheel speed sensor wire) | 0.9 1 1.1 Q |
| 14 - Body earth | Front-left solenoid valve (IN side) | 9.0 + 0.5 Q |
| 15 _ Body earth Body earth 25 | ABS-ECU earth | Continuity |
| 39-43 | Idle-up solenoid valve | 36 - 44 $2 |
| Body earth 41 | Front-right solenoid valve (OUT side) | 4.7 +0.25 Q |
| 42 Body earth | ABS ECU earth | Continuity |
| Body earth 48 | Valve relay monitor input | Continuity |
| 49 Body earth | Motor monitor | Continuity |
| Body earth 52 | Front-right solenoid valve (IN side) | 9.0 + 0.5 9 |
Оригинальная страница руководства
