Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 101 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Service Adjustment Procedures

BRAKE LINING THICKNESS CHECK

Remove the rear brake assembly and secure it with wire.
2Remove the brake drum.

3Measure the wear of the brake lining at the place worn
the most

Standard value:

6.5 mm (0.256 in.)
4.5 mm (0.177 in:)

Limit:

Replacetheshoeand lining assemblyifbrakelining
thickness is less thanthe limit if it is notworn evenly:
For information concerning the procedures for installation
of the shoe andliningassembly, referto GROUP 36
Parking Brake Drum.

Caution

Whenevertheshoeandliningassemblyis
replaced, replace both RH and LH assemblies as
set to prevent car from pulling to one side when
braking:

2Ifthereissignificantdifferenceinthethick-
nesses of the shoe and lining assemblies onthe
left and right sides, check the sliding condition of
the piston:

BRAKE DRUM INSIDE DIAMETER CHECKE3SFGAA

Remove the rear brake assembly and secure it with wire_
2Remove the brake drum_
Measure the inside diameter of the brake drum at tWO Or
more locations

Standard value:197mm (7.76 in )
Limit:198 mm (7.8 in )

Replace brake drums and shoe ad lining assembly when
wear exceeds the limit value or is badly imbalanced:

BRAKELININGANDBRAKEDRUMCONNEC- TION CHECKE35FIAA

Remove the rear brake assembly and secure it with wire.
2Remove the brake drum

3Remove the shoe ad lining assembly, refer to GROUP
36Parking Brake Drum
Chalk inner surface of brake drum and rub with shoe and
lining assembly.

Replace shoe andliningassembly or brake drums ifvery

irregular contact area.

6For information concerning the procedures for installation
of the shoe adliningassembly, refer to GROUP 36
Parking Brake Drum:

NOTE

Wipe off chalk after check.

Оригинальная страница руководства