WHEEL SPEED SENSOR OUTPUT VOLTAGE MEASUREMENT <A.B.S.> · 103 — Pajero II 1991–1998 — руководство по ремонту

WHEEL SPEED SENSOR OUTPUT VOLTAGE MEASUREMENT <A.B.S.> · 103

WHEEL SPEED SENSOR OUTPUT VOLTAGE MEASUREMENT <A.B.S.> · 103

Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 103 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Иллюстрация 1, страница 103

5.If the output voltage is lower than the above values, the
reason could be as follows:

Excessive clearancebetweenthewheel speed sen-

sor pole piece and the rotor
Wheel speed sensor is defective

If necessary, adjust the wheel speed sensor or replace it:

6_Next, to observe the output of the wheel speed sensors,
move the transfer shift lever to4Hand the transmis-
sioncontrol leverto(MTvehicles)orDrange
(AT vehicles) , and rotate the wheels_
NOTE

Check the connection of the sensor harness and con-
nector before using the oscilloscope

2Thewaveformmeasurementscanalsobetaken
while the vehicle is actually moving:

3Theoutput voltagewillbe smallwhenthewheel
speed is low, ad similarly it will be large when the
wheel speed is high:

WAVE OBSERVATION POINTS

Таблица в оригиналеТаблица: оригинал страницы 103
Распознанный текст таблицы — требует сверки с оригиналом
SymptomCauseSuggested remedy
Wave amplitude is too small,
Or
'
Wheel speed sensor is detectiveReplace the sensor
doesnt appear at allWrong clearance between the
pole piece and rotor
Adjust the clearance
Excessive variation in the wave
amplitude
(However, if the lowest amplitude
'20OmV-p-p, there is no
occurs at
problem)
Excessive runout or eccentricity in
the axle hub
Replace the hub
Noise or interference in the waveBroken sensor wireReplace the sensor
patternBroken harness wireRepair the harness
Defective wheel speed sensor
attachment
Repair the sensor attachment
Eccentric rotor or broken rotor
teeth
Replace the rotor

NOTE

Asthewheel speed sensor harnessmove in conjunctionwiththemovement of the front ad rear
suspension, the wires might break while driving on rough roads, but may have continuity while driving
on normal roads. Accordingly, when measuring the wave pattern of the wheel speed sensor output volt-
age,takemeasurement while shaking the sensorharnessto simulatethe special conditions of
rough road:

Оригинальная страница руководства
Страница 103
100%

Назад
Сверху