Pajero II Workshop Manual 1991 · SERVICE BRAKES · страница 98 из 140 · Открыть оригинал PDF ↗

Текст распознан со скана. Числа и обозначения можно сверить с оригиналом ниже.

Service Adjustment Procedures

REARDISCBRAKEPADCHECKAND
REPLACEMENTE3SFUAC
Check brakepadthickness through caliper body check port
Standard value:9.0 mm (0.35 in.)
Limit:2.0 mm (0.079 in:)

Caution

When the limit is exceeded, replace the pads at both
sides, and also the brake pads for the wheels on the
opposite side at the same time

2If there is a significant difference in the thicknesses
of the pads on the left and right sides, check the slid-
ingcondition of the piston, lock pin sleeve and guide
pin sleeve:

Remove lock pin. Lift caliper assembly and retain with wires_
Caution

Do not wipe off the special grease that is on the lock pin
or allow it to contaminate the lock pin:

3Remove the following parts from caliper support.
(1)Outer shim

(21Pad assembly

(31 Pad and wear indicator assembly

(4) Clip

In order to measure the dragging force of the disc brakes af-
ter installation of the brake pads, use a spring balance to
measure the rotationalsliding resistance of the hub in the
forward direction with the pads remove

NOTE

To secure the disc to the hub, tighten the nuts.

Securely attach thepadclip to the caliper support

Caution

Do not deposit grease or other dirt onpador brake disc
friction surfaces.

Оригинальная страница руководства