MANUAL LINKAGE

1989-Montero · auto tranny · страница 23 из 109 · Открыть оригинал PDF ↗

The inhibitor switch is installed on the selector
lever. After checking normal operation of this
switch, place the selector lever in the “N” position.
If the notch of the selector lever on the transmis-
sion side faces directly down, the linkage has been
adjusted correctly.

THROTTLE CONTROL CABLE

Throttle control cable adjustment is very important
to assure normal operation of the transmission.
Shift speed control, shift feeling and transmission
slip depend greatly on this adjustment.
If the throttle outer cable is set too long (namely.
the inner cable is too tight], the throttle valve is
already in operating state and consequently,
presense of hydraulic pressure higher than
specified is suspected. The throttle pressure acts
on each shift valve and when upshifting, the gover-
nor pressure that counteracts against the throttle
pressure is higher than normal. Namely, if the outer
cable is set too long, upshift takes place at vehicle
speed higherthan normal.
On the other hand, if the outer cable is set too short
(the inner cable is slack), upshift takes at vehicle
speed lower than normal.

INHIBITOR SWITCH

Check to see that the engine starts only when the
selector lever is in the “N” or “P” position and that it
does not start when the selector lever is in other
positions.

SELECTOR LEVER

(1) Check to see that the vehicle moves forward
when the selector lever is shifted from the “N”
position to the “D” range and that the vehicle
reverses when the lever is shifted to the ‘5”
range.

(2) Stop the engine.

(3) Shift the selector lever from the “N” position to
the “D” range and then to the “2” position to
check that the Tever can be operated smoothly
and engage at each position with reasonable
firmness. L

(4) Check to see that shifting to each of the “P”,
“R”, “2” and “L” positions can take place only
when the selector lever is pushed in.