1989-Montero · auto tranny · страница 82 из 109 · Открыть оригинал PDF ↗
ASSEMBLY
(I) Install the thrust bearing race #I8 and rear planetary ring
gear on the intermediate shaft as follows:
Slip the thrust bearing race and ring gear onto the
intermediate shaft with the exterior splines up, as shown,
(2) Install the set ring on the intermediate shaft.
Make sure the rear planetary ring gear is secure on the
intermediate shaft.
(3) ply over the intermediate shaft and install thrust bearing
(4) Install the pinion gear assembly and nylon thrust washer on
the rear planetary carrier.
Install the washer with the lugs down, fitting them into the
rear planetary gear carrier.
Caution
l Make sure the different lug shapes match the
openings on the plate.
(5) Install the three oil seal rings on the output shaft by
spreading apart and sliding them into the groove.
Hook both ends by hand.
(6) Use the extension housing as an assembly stand.
(7) Install the thrust bearing #20 and race #I9 on the output
shaft.
(8) Install the intermediate shaft assembly in the output shaft.
(9) Install the rear planetary gear in the output shaft.
(10)lnstall the planetary sun gear in the rear planetary gear.
Оригинальная страница руководства
