1989-Montero · auto tranny · страница 61 из 109 · Открыть оригинал PDF ↗
FRONT OIL SEAL CHECK
(1) Check for wear, damage or cracks.
If necessary, replace the oil seal by the following steps.
(2) Pry off the oil seal with a screwdriver.
(3) install a new oil seal.
NOTE
The seal end should be flush with outer edge of pump
body.
REASSEMBLY
(1) Set the oil pump body on the torque converter.
(2) Install the driven and drive gears on the oil pump body in
correct directions according to the marks put during
disassembly.
(31 Install the oil pump cover on the body.
(41 Align the bolt holes in cover with those in body.
Install the six bolts with wave washers finger tight.
(5) install the special tool around the oil pump body and cover.
Tighten the special tool to align the body and cover.
Tighten the six pump cover bolts to the specified torque.
I;; Remove the special tool.
(8) install the two seal rings on the pump cover by spreading
apart and sliding them into the groove.
Hook both ends by hand.
(9) Install a new O-ring on the pump.
Make sure the O-ring is not twisted and is fully seated in the
groove.
Оригинальная страница руководства
