1989-Montero · auto tranny · страница 37 из 109 · Открыть оригинал PDF ↗
(2) Remove the dust cover, and then remove the snap ring
that holds the spring.
(3) Remove the cross shaft bracket mounting bolts from
the transfer assembly.
(4) Detach the cross shaft bracket from the bracket on the
No. 1 crossmember side.
(5) Remove transmission control rod A from the transmis-
sion.
SERVICE POlNTS OF INSTALLATION N2IIoAn‘
26.APPLlCATlON OF GREASE TO PIN/25 BUSHING/24.
CROSS SHAFT BOOT/23. CROSS SHAFT BRACKET
(A)/22. BUSHING/20. TRANSMISSION CONTROL ROD
(A)/19. SELECT CROSS SHAFT/lS. CROSS SHAFT
BOOT (B)/17. CROSS SHAFT BUSHING/lG. SPRING
Apply a coating of the multipurpose grease to the bushing
inner surface and the sliding parts shown in the figure.
13. INSTALLATION OF TRANSMISSION CONTROL ROD (B)
(1) Move the transmission and shift lever to the “N”
position, and then install the transmission control arm
and transmission control rod (B) as shown in the figure.
(2) Check, while driving, to be sure that the transmission is
set to each range when the selector lever is shifted to
each position.
(3) Check, while driving, to be sure that the overdrive is
activated and cancelled correctly when the overdrive
switch is used.
Оригинальная страница руководства
