1989-Montero · auto tranny · страница 38 из 109 · Открыть оригинал PDF ↗
dSASSEMBLY AND REASSEMBLY
Removal steps
1. Position indicator light 18
r)+ 2. Inhibitor switch
3. Overdrive switch
l 4 4. Pushbutton
5. Spring 8
6. Selector handle
I)* 7. Bushings
I)* 8. Transmission control arm
9. Shift lever
** 10. Sleeve
l * 11. Spring
I)* 12. Rod assembly
13. Bracket
NOTE
(I) Reverse the disassembly procedures to reassemble.
(2) I)+ : Refer to “Service Points of Reassembly”.
N2lmAC
Проверка
l Check for unusual wear of the bracket’s detent plate part,
rod end pin, each bushing, pushbutton and sleeve contact
surface.
l Check for weakness of the spring.
l Check the operation of the overdrive switch. (Check the
continuity.)
When the overdrive switch is OFF: continuity
When the overdrive switch is ON: non-continuity
Inhibitor switch
I
Check the continuity with the select lever at each position.
NOTE
m indicates that there is continuity between the terminals.
Оригинальная страница руководства
