1989-Montero · auto tranny · страница 70 из 109 · Открыть оригинал PDF ↗
(8) Set the special tool on the spring retainer and compress the
clutch return springs with a shop press.
Using a screwdriver, remove the snap ring.
(9) Remove the special tool, then remove the spring retainer
and eighteen clutch return springs.
(10)Assemble the forward clutch cylinder and piston on the
overdrive case and force out the piston by compressed air:
(a) Slide the foward clutch cylinder and piston onto the
overdrive case.
(b) Apply compressed air to the overdrive case to remove
the piston.
(c) Remove the forward clutch cylinder from the overdrive
case.
(11 )Remove the O-rings from the forward clutch piston.
Проверка
FORWARD CLUTCH PISTON
(I 1 Check that check ball is free by shaking the forward clutch
piston.
(2) Check that the valve does not leak by applying low-pressure
compressed air.
NOTE
Prepare new discs by soaking them at least two hours in
ATF.
ASSEMBLY
(I) Install new O-rings on the forward clutch piston.
Coat the O-rings with ATF.
(2) Press the forward clutch piston into the forward clutch
cylinder with the cup side up (check ball down).
Be careful not to damage the O-rings.
(3) Install the eighteen clutch return springs, spring retainer
and snap ring in place.
(4) Compress the clutch return springs and install snap ring in
the groove:
(a) Set the special tool on the spring retainer, and com-
press the springs on a shop press.
(b) Install the snap ring using a screwdriver.
Be sure the end gap of snap ring is not aligned with the
spring retainer claw.
Оригинальная страница руководства
