1989-Montero · auto tranny · страница 71 из 109 · Открыть оригинал PDF ↗
(5) Install the clutch discs and plates without assembling the
snap ring.
NOTE
A new clutch disc should be soaked in ATF for at least two
hours before installation.
(a) Using low-pressure compressed air, blow all excess -
ATF from discs. mm
Caution
l High-pressure air will damage discs.
lb) Install the clutch plates and discs alternately. Do not
install the snap ring (thinner) yet.
(6) Check the piston stroke of forward clutch:
(a) install the direct clutch hub and snap ring.
(b) Install the forward clutch cylinder assembly onto the
overdrive case.
Using a dial indicator, measure the stroke applying and
releasing the compressed air (400-800 kPa. 58-116
psi).
Standard stroke: 1.43-2.93 mm (.0563-.I164 in.)
If the stroke exceeds the limit, the clutch discs and/or
plates are-probably worn. If the stroke is less than the
limit, parts may be misassembled or there may be
excess ATF on the discs.
(c) After the check, remove the snap ring and direct clutch
hub.
(7) Compress and lower the snap ring into the groove by hand.
Check that the ends of the snap ring are not aligned with
any of the cutouts.
03) Install the clutch disc. -
(9) Install the thrust bearing #I2 and the races #I 1 and #13,
all coated with petroleum jelly.
(10)lnstall the forward clutch hub while aligning the disc lugs
with the hub teeth. Make sure the hub meshes with all the
discs and IS fully inserted.
Оригинальная страница руководства
