1989-Montero · auto tranny · страница 54 из 109 · Открыть оригинал PDF ↗
(22)Check for correct installation of the overdrive clutch as
follows:
Set the special tool on the overdrive case as shown in the
figure.
Measure the distance between the top surface of the tool
and the overdrive clutch. If the distance corresponds to that
during disassembly, the overdrive clutch is installed correct-
Iv.
(23)lnstall the O-ring on the overdrive case.
(24)lnstall the torque converter housing by using the two
12-mm bolts (B) and four IO-mm bolts (A).
Tighten the bolts to specification.
(25)Coat the thrust bearing race #3 with petroleum jelly and
install it on the overdrive clutch.
(26)Coat the thrust bearing #2 and race #I combination with
petroleum jelly and install it on the oil pump.
(27)lnstall the oil pump:
(a) Install the oil pump gently through the two guide bolts,
being careful’ that the thrust washer does not fall out.
(b) Coat the five set bolts with sealant, and finger tighten
them.
(cl Using a screwdriver, remove the special tool. In the
place of it, install the two set bolts coated with sealant.
Specifiedsealant: 3M ART Part No. 8666
or equivalent
(d) Tighten the set bolts gradually and evenly to the
specified torque.
(28)Tighten the two center support bolts alternately in 7 Nm
(5.16 ftlbs.) increments until the specified torque is
reached.
NOTE
Firest tighten the accumulator side bolt.
Оригинальная страница руководства
