1989-Montero · auto tranny · страница 59 из 109 · Открыть оригинал PDF ↗
GENERAL NOTES ON DISASSEMBLY AND ASSEMBLY Of COMPO- W1NEAA NENT ASSEMBLIES
W1NEAA
GENERAL CLEANING NOTES:
GENERAL ASSEMBLY NOTES:
(1) All disassembled parts should be washed clean
and the fluid passages and hole blown through
with compressed air to make sure that they are
not clogged.
(1) All -oil seal rings, clutch discs, clutch plates,
rotating parts, and sliding surfaces should be
coated with ATF prior to reassembly.
(2) All gaskets and O-rings should be replaced.
(3) Make sure that the ends of a snap ring are not
aligned with one of the cutouts and are in-
stalled in the groove correctly.
(4) If a worn bushing is to be replaced, the
replacement must be made with the compo-
nent assembly containing that bushing.
(5) Check thrust bearings and races for wear or
damage. Replace if necessary.
(6) Use petroleum jelly to keep parts in their
places.
(2) The cleaning solvent used should be the rec-
ommended ATF or kerosene.
(3) When using compressed air to dry parts, avoid
spraying ATF or kerosene in your face.
PARTS HANDLING NOTES:
(1) After cleaning. the parts should be arranged in
proper order to allow performing the inspec-
tion, repairs, and reassembly with efficiency.
(2) When disassembling the valve body, be sure to
keep each valve together with its own spring.
(3) New brake and clutch discs that are to be used
for replacement must be soaked in ATF for at
least two hours before assembly.
Масляный насос
Оригинальная страница руководства
