1989-Montero · auto tranny · страница 52 из 109 · Открыть оригинал PDF ↗
(10)lnstall the direct clutch in the case while turning the clutch
to mesh its hub with the center support.
(11)Check for correct installation of the direct clutch.
If the direct clutch is fully meshed with the center support,
the splined center of the clutch will be flush with the end of
the planetary sun gear shaft.
(12)After being coated with petroleum jelly, install the thrust
bearing race #I 6 over the splined end of the direct clutch in
case with its lip toward the direct clutch.
(13)After being coated with petroleum jelly, install the thrust
bearing #I5 and race #I4 on the forward clutch, with the
race’s lip outward.
(14)lnstall the forward clutch assembly in the case:
(a) Align flukes of the direct clutch discs and mesh them
with the forward clutch hub.
(b) Push the forward clutch assembly into the case.
Caution
0 Be careful not to let the thrust bearing drop.
(15)Check for correct installation of the forward clutch as
ulD998217
follows:
\/F
Set the special tool on the transmission case as shown in
the figure.
Measure the distance between the top surface of the tool
and forward clutch assembly. If the distance corresponds to
that during disassembly, the forward clutch is installed
correctly.
Оригинальная страница руководства
