1989-Mitsu-Factory Manual · Передняя подвеска · страница 19 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF INSTALLATION
NLUGDAH
l ADJUSTMENT OF WHEEL BEARING PRELOAD
(1) Using the special tool, tighten the lock nut by the
following procedures.
Tighten to 130-200 Nm (94-145 ft.lbs.) 1
t
I Loosen to 0 Nm (0 ftlbs.)
t
Retighten to 25 Nm (18 ftlbs.) and then loosen 30”-40”
(2) Loosen the lock nut approximately 30 to 40 degrees to
adjust the front hub’s turning resistance and play in
the axial direction so that they agree with the standard
values.
Standard value : 0.3-1.3 Nm
(2.6-11.3 in.lbs.)
[Spring scale reading]
4.3-18.6 N (0.944.10 Ibs.)
Standardvalue : 0.05 mm (.OOZO in.) or less
NOTE
If adjustment is not possible, the bearing may be
incorrectly installed; check and, if necessary, repair.
The lubrication condition should also be checked.
(3) Mount the lock washer. If the lock washer holes do not
align with the lock nut holes, loosen the lock nut (no
more than 30 to 40 degrees) to align them.
6. INSTALLATION OF AUTOMATIC FREE-WHEELING HUB
ASSEMBLY
(1) Apply a coating of specified sealant, equally all around
and without any missed spots, to the free-wheeling
hub body assembly and front hub contact surfaces.
Specified sealant : 3M ART Part No. 8663 or equiva-
lent
Caution
Make sure that there is no excess semi-drying
sealant on the hub outside surface.
Оригинальная страница руководства
