1989-Mitsu-Factory Manual · Передняя подвеска · страница 26 из 66 · Открыть оригинал PDF ↗
FRONT SUSPENSION - Shock Absorber and Upper Arm
SERVICE POINTS OF REMOVAL hwhmw
2. LOOSENING OF ANCNOR ARM ASSEMBLY ADJUSTING
NUT
Loosen the anchor bolt of the torsion bar all the way.
NOTE
When the anchor arm assembly adjusting nut is loosened,
use a jack to support the lower arm of the side to be loosen-
ed, thus the work easier.
6. DISCONNECTION OF UPPER BALL JOINT AND
KNUCKLE
(I) Loosen the nut tightening the upper ball joint to the
knuckle.
NOTE
The nut should be partially loosened and should not be
removed.
(2) Using a special tool, disconnect the upper ball joint
from the knuckle.
10. REMOVAL OF UPPER ARM
(1) Remove the upper arm installation bolts.
(2) Move the rear end of upper arm toward the rear and
take out the front end.
(3) Take out the rear end of upper arm.
If the shaft comes in touch with the bracket, turn the
shaft to take it out.
Оригинальная страница руководства
