1989-Mitsu-Factory Manual · Передняя подвеска · страница 37 из 66 · Открыть оригинал PDF ↗
SERVICE POINTS OF REMOVAL
2. REMOVAL OF ANCHOR ARM ASSEMBLY
Support the lower arm from which the torsion bar is to be
removed, with a jack.
Проверка
NozacAA
0 Check the torsion bar for bends or damage.
l Check the dust cover for cracks or damage.
SERVICE POINTS OF INSTALLATION
Nclz.sDAa.
Apply the multipurpose grease to the torsion bar serrations,
the anchor arm assembly serrations. the anchor arm B
serrations. the dust cover inside and the anchor bolt thread.
5. INSTALLATION OF TORSION BAR
(I) Identify the right and left torsion bars referring to the
identification mark put on the torsion bars.
Face the end having identification mark forward, and
align the mark on anchor arm B with the mating mark
on torsion bar when the torsion bar is inserted in the
anchor arm B.
NOTE
When installing a new torsion bar, align the serration
painted white with the mark on anchor arm B.
(2) Select the relative position of the torsion bar serrations
and the anchor arm serrations so that the length shown
in the illustration may have specified dimension when
the torsion bar and the anchor arm are assembled, with
the upper arm rebound stopper in contact with the
crossmember.
Standard value : L.H. 135.2-143.2 mm (5.323-6.638
in.)
R.H. 124.3-132.3 mm (4.894-5.210
in.)
Оригинальная страница руководства
