1989-Mitsu-Factory Manual · Передняя подвеска · страница 52 из 66 · Открыть оригинал PDF ↗
Front Differential Mounting
SERVlCE POINTS OF REMOVAL
NOZOBAB
2. REMOVAL OF DRIVE SHAFT
Refer to P. 240.
4. REMOVAL OF INNER SHAFT
Attach the special tools to the flange of the shaft. and
drive the inner shaft out fmm the front differential carrier.
:
Caution
1. Being careful not ato scratch OP scar the shock
absorber with the special tool, remove the lower
mounting bolts of the shock absorber, and compress
the shock absorber as much as possible.
2. When pulling the inner shaft out from the front
differential carrier, be careful that the spline part of
the inner shaft does not damage the oil seal.
9. REMOVAL OF DIFFERENTIAL MOUNTlNG BRACKET
(L.H.) / 13. DIFFERENTIAL MOUNTiNG BRACKET (R.H.)
While supporting the differential carrier with a jack, remove
the differential mounting bracket.
NOTE
Support the differential carrier with a jack until installing
the differential mounting bracket.
Проверка
No*“cm
@ Check the differential mounting bracket for deformation
and damage.
@ Check the bracket for deformation and damage.
@ Check the differential mounting rubber for cracks and
damage.
SERVICE POINTS OF INSTALLATION NOZUDP9,
4. INSTALLATION OF INNER SHAFT
Drive the inner shaft into the front differential carrier by
using the special tools.
Caution
Be careful not to damage the lip of the dust seal and oil
seal.
2. INSTALLATION OF DRIVE SHAFT
Refer to P. 240.
Оригинальная страница руководства
