1989-Mitsu-Factory Manual · Передняя подвеска · страница 39 из 66 · Открыть оригинал PDF ↗
STABlUZER BAR REMOVAL AND INSTALLATION
NwrA-
Проверка
rauTuA
l Check the stabilizer bar for deformation or damage.
l Check the hanger for bends or damage.
l Check the rubber parts for cracks, deterioration or wear.
SERVICE POINTS OF INSTALLATION
NWTDAA
7. INSTALLATION OF STABILIZER BAR
When installing the hanger to the stabilizer bracket, tighten
the nut so as to obtain the specified dimension.
Standard value : 6-8 mm (.24-.31 in.)
When installing both ends of the stabilizer bar to the lower
arms, tighten the nut. so as to obtain the specified
dimension.
Standard value : 6-3 mm (.24-.31 in.)
NOTE
The dimension shown in the figure is the value when a
new bushing is used.
Оригинальная страница руководства
